Thursday, January 7, 2010

Towel Warmer Radiator How Can I Stop A New Radiator Valve Tail From Leaking- Help!?

How can I stop a new radiator valve tail from leaking- help!? - towel warmer radiator

I'm trying to replace a heater with a hot towel. The system uses plastic tubing very flexible, which allows me connect to the radiator and heated towel rails at once in touch, and the dimensions must be removed similarly.

The problem I have with the valve shaft by screws, bolts together, everything seems OK and I use PTFE tape wound in the right direction. Whenever I return to the leaking purge valve, and I am the mother of the valve connect to the queue of the valve. I've tried to do it again a few times, again with a tail, but in vain. The mother does not seem to be the wire or breaking or anything.

This project is my first heat, so I hope someone has some tips on how to get a better seal.

3 comments:

julie w said...

It is the loss of a flood or just on a boat? Installed my other half "," only the first radiator and found a ship, even after adding the PTFE tape ... but as we busy with something else, so we left a plate below ... Then after 4 days there was no drop again and I feel good now! Perhaps it is worthwhile to see if we are "calm" if it is only a small boat ...

nosdda said...

You need to fill the seat of the nut paste with the white union leaders in hardware stores or home improvement stores and so on. Although both sides will be processed the mother, needs not only a highlight for small leaks allow. When you paste on both sides must be dried.

johncob said...

Use PTFE Gas Tape is "much heavier than normal thin version. Save smear band with a few" Fernox LS X '(the original or good plumber) X TB as a silicone sealant.

Post a Comment